I am running 12.2 (55)SE3 code on a 2960s stack with the power inline 2x-mode configured on the interface and still getting a consistent "Tstart error condition" the PD is an Ingenico iSC Touch 480
... View more
Hey Evan, Do you happen to have any configuration examples of the switch and corresponding wlc interfaces for both the management and wlan ports. Also, your opinion on the benefits of using LAG and any config examples there if possible. thanks.
... View more
Thanks for confirming my belief. I expected the L3 limitation with the expectation that an end device would not be able to perform a seamless roam, but rather would re-associate to the same ssid and receive new addressing via dhcp.
... View more
Is it possible to assign a single ssid to multiple interface groups by assigning the ssid to multiple AP groups? I have buildings geographically dispersed that are configured with multiple vlans in interface groups so that I can maintain an addressing scheme of dhcp assigned addresses per building. Each building is also further grouped as AP groups. I'd like to know if by assigning the same wlan ssid to each of the AP groups, will I maintain addressing integrity for each building? I'm thinking it will work. Do the buildings have to be outside AP range of each other to avoid problems? What gotchas should I be aware of? 5508 controller 7.2.110.0 code 6 buildings 6 interface groups 1 ssid
... View more
.jpg "Hall of Fame Master"){kind=icon}
