Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco ASA 5520 (Ver 8.2(4)) with all four interfaces in use (Public, Private, DMZ, Local offices) and an IPS module, so there are no spare interfaces. I have used all of Public IP's on the current interface for various services (these need o...
I have an issue where our ASA 5520 is impacting upload (from LAN to internet) speed.We have a 100Mbps SDSL internet link and only see around 45-50 Mbps on the upload when going via the firewall, download is around 90+ Mbps so that is acceptable.I hav...
How can we host 300+ secure (https) websites using a couple of public IP's on an ASA5520 with AIP SSM-20 and with as few certificates as possible?Summary of set-up:We currently host a number of websites using an ASA5520 and use host headers, so have ...
A couple of times now, an ASA5520 - Software Version 7.1(2) stops passing traffic (no changes made to the ASA for weeks). The interfaces are up/up (one is connected to a 3750 (full/1000Mbps) and the other to a LES100 circuit (full/100Mbps) and no err...
If the BANDWIDTH statement is changed on a serial interface to a value differant to the physical properties of that interface (to effect a routing metric) does it effect the calculation of the RXLOAD & TXLOAD?
Jennifer,Thanks for the quick reply.You were pretty much correct, all I needed to do was create the appropriate NAT map between the Public IP & a DMZ server and also add a new RULE to allow the new public facing services to be available for internet ...
Thanks for taking the time to reply, however that BUG ID is not the issue:CSCse08133 Bug DetailsSSH and other to the box traffic denied because of no connectionSymptom:After a period of time, administrators are unable to SSH, or ping the interfaceof ...
It looks like I have answered my own question again.There is a BGP timer command that is set in the router configuration mode: timers bgp where keepalive is default at 60 secs and holdtime is 180 secs. I just need to determine the most appropriate ...
Thank you for your offer of assistance, I have added: neighbor 192.168.2.83 weight 65535to the router with the 2Mb link. Now the routes are correct when the 2Mb link is restored, however this takes 3mins. I now would like to reduce this to as shor...
