Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What we’d like to know is the basic outline for performing redundancy of internet services with multiple ISPs through the PIX… (PIX-515E-FO-FE)What we need to be able to configure is as follows:SMTP inbound server A DMZ = 192.168.1.1SMTP inbound serv...
Scenario, We have a number of static VPN’s (over 10) over GRE tunnels between Hong Kong (HKG) and Mainland China. (SITEA, SITEB, SITEC, etc…) Each remote office is using an 831 router with most offices having a single FTTP 3Mbps internet connection. ...
Hopefully this should be an easy one.We have an 837 ADSL router configured and operational, the DSL appears fine and tests out OK.The problem only occurs once we enable the VPN, the VPN establishes normally but after about 20secs of successfully push...
OK, we managed to find a solution for this:When Telefonica sent us the configuration details of the new line they included a “gestión IP” address which is management IP in English.We then shutdown the ilmi completely since it simply wasn’t working in...
We have the exact same issue with an 877 router connected to a Telefonica ADSL2+ line in Spain.After searching, it appear other people have the same issue but nobody seems to have an answer. We tried the “"disable-ilmi-enterprise-traps" hidden comman...
There must be some way around it, if other Firewalls are capable of doing this then surely Cisco must be heading down a similar path. The stonegate firewall even sends a SYN packet out each internet connection for each new session and then uses the i...
We have a similar question.In one office we use a 2651 with a AIM-VPN module to terminate the VPN clients, the route for the client is then entered into the local routing table using ‘reverse-route’ on the crypto map. Distribution is then by EIGRP or...
Many thanks for the quick response,I read a bit about OER and it seems to suit the configuration we want to implement. It doesn’t however seem quite ready yet for the routers we have installed, certainly something to look out for in the future.EIGRP ...
