My 1310 bridge with code 12.4(10b)JDA2 shows this warning even when the temperature is -12C. I know that 1310 works between -30C to 55C.Anyone has a clue.
Hi Carl, I would beg to differ from others here. I would actually recommend using APs in Flexconnect mode to save money and bandwidth. The whole purpose behind developing the Flex mode was to save money and bandwidth on across the WAn links.++ You ca...
Hi , You might also need to check if these APs were in Flexconnect mode. If yes, please check the native VLAN on the uplink switchport. There are chances (as others mentioned) that the switchport config has changed after a reboot. HTH,Tony
Sorry. I forgot to answer your basic issue.You can use the command "sh dot11 network-map" on the repeater to see the APs in the near vicinity.Then u can check which one is a root AP and get its MAC address.This MAC address can be specified as a paren...
Hi Difan,To specify the root AP for your repeater you can use the command "parent 1-4 MAC address"You can specify up to 4 root APs for a repeater AP. A repeater works better if you specify the root AP for it.Cheers,Manish
Hi Dan,This issue is a bit complicated.Thefix consists of a software change to a hardware configuration register. You will have to get the device RMAed from Cisco.Cheers,Manish
