Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Do the active auto-discovery flows count as a licensed flow? My understanding is that those are flows that have not been fully set up to become optimized or pass-through. If I am licensed for 2500 concurrent connections, do the active auto-discovery...
Looking to understand why I don't always see the PT reason noted correctly.
Scenario:
I have a WAAS at site A and a WAAS at site B. Both run 5.3.1 code. Neither go into TFO overload.
I have a policy configured with action = Passthrough for destinat...
Why does the SRE module not indicate it has received any Pause request from the router?
Are the ge_tx_interrupts/ge_rx_interrupts on the SRE module interface of great concern?
The Pause Outputs from the router on the SMx/x interface is seen in most o...
Has anyone configured the SRE module external interface for packet capture traffic? Scenario-- Router gig0/0--->Ethernet TAP--->WAN
The router has an SRE running WAAS software. The Ethernet TAP is a passive 3-port switch that will replicate the tra...
Has anyone successfully implemented TACACS authentication TO the CM GUI? I have the CM configured for TACACS authentication to the WAE devices GUI and CLI - that works fine with the admin role assigned. It does not work for authentication to the CM...
Hi,
Yes, I checked the B side. Both sides showed the same behavior. I expect to see PT App Cfg as the reason, but not both PT App Cfg and PT In Progress. I also verified that the policies were correct on both WAAS.
Here is the snip of the config s...
Jorge,
I will open a TAC case on this given that this is a systemic symptom in every ISR G2 router deployed with SRE module running the WAAS software. I expect to see that the SRE module is receiving the pause frame from the router and that it will ...
Jorge,
I have now looked at all 97 SRE modules in production. Router platforms are ISR G2 2911 & 2951. The 2911's have the SRE-700 and the 2951's have a SRE-900 or SRE-910.Here is what I've found, which is irrespective to any SRE TFO overloads and ir...
Final Update and resolution: TAC was able to review all the logs and find 7 optimization policies that 'failed' thereby causing the device group setting for the Optimization Policies to drop and revert to "Select a device group".Of those 7 policies,...
