Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
OSPF neighbor can't come up on a DMVPN spoke.
It all started with this message. Tun0 interface has always been up and connectivity has been verified.
*Apr 17 15:26:13.312: %OSPF-5-ADJCHG: Process 302, Nbr100.10.0.1 on Tunnel0 from FULL to DOWN, Neig...
If a router supports wide metric, does it necessarily use wide metric if the EIGRP process is in named mode?
R1#show eigrp protocols EIGRP-IPv4 VR(init-eigrp) Address-Family Protocol for AS(100) Metric weight K1=1, K2=0, K3=1, K4=0, K5=0 K6=0 Metri...
Why making a CLI parser so bulky, requiring installation and admin priv? What about linux support?
All I need is something that takes the input from file and parse it locally in a human-readable format, a cli tool would totally get the job done. Why...
So a week later I revisited this issue, and found `shutdown` under the OSPF process. Removing `shutdown` solved the problem.
The error message is somewhat vague. I am surprised nobody has run into this issue before. Not sure why the process was shut...
For service-policy configured on satellite access port, is there any difference between service-policy under nv and service-policy directly under gi10x/0/x (without nv)?
As Xander pointed out, VQI is per ICL, not per satellite access port. Ingress NP can send more than 1Gbps destined to a single access port across fabric to egress NP. When the 10G VQI for ICL fills up, default queue would start to drop, including tra...
Hi Adam,
The concern here is bps, not pps. We had to move some customer ports around to avoid drops on other customer ports pinned on the same ICL when there's a >10Gbps attack.
