Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a multiisite hub and spoke VPN network. Is there any way to configure the end points to initiate the tunneling for the multiple subnets they are carrying, without traffic being geneterated to each subnet. IE. site a is 1.1.1.1 site b is 2.2....
I have a new VPN network setup with 8 branch offices connected back to head quarters. The new challenge I have been given is that they need each of the branch offices to communicate across the VPN tunnel. The HQ VPN device is an ASA 5510 and the br...
I've been tasked with adding a dual WAN solution for our office. We currently have an ASA 5510 with one internet provider (the ASA is the border device). We have a site to site VPN end-point terminating on this device, many PAT statements for our 1...
Hello allI have an issue, of two parts. The first part I believe I have figured out, just the second part I am unsure of. I have an ASA 5510, currently, there is a mailserver that is static NAT'ed to one of my ISP routed IPs (not the IP of my main Dy...
I have a 5510 at HQ, and will need to setup 9 5505s at remote sites. The remote sites unfortunately, have dynamic IP addresses. I've been searching for a while for configuration examples for setting up the site to site vpns using dynamic hostname....
The vpns are site to site, each of the spokes connect directly to the hub. Each spoke is a dynamic ip with the hub being static. each spoke only has one vpn peer and that is the hub, and the "main" subnet at the hub is tunneled immediately when the...
Traffic (any) can flow from each remote site to HQ, but not from site to site. The remote sites all have dynamic public IPs and the HQ is the only static public IP so remote site to remote site vpns are not feasible. i need to setup traffic to rout...
awesome, thank you for the input! So if I have static 1 to 1 mappings, my ASA and wan router will have to have their own private /24 network inside to handle all the translations, correct? And, I was incorrect about the amount of bandth, its 100/10 ...
