I cannot configure a tunnel interface on a Nexus 7kfeature tunnel was enabled config: clu# configure terminalEnter configuration commands, one per line. End with CNTL/Z.clu(config)# feature tunnelclu(config)# interface tunnel 0clu(c...
Hi Amit,we changed the ACLs a bit, so "Protcol CAM" utilization is below 100 percent, but it is still impossible to configure tunnel interface. Any other ideas?Cheers, Holger
Hi Amit,I got the outputs from both commands. I wonder if you can see anything out of it. How can I add these file to this forum (it' s the first I am using it ;-)Cheers,Holger
Hi,there are only a few (8) ACL's configured.Output from Show system internal access-list resource utilization:slot 2=======INSTANCE 0x0------------- ACL Hardware Resource Utilization (Mod 2) ------------------------------------------...
