Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning,
Here is the situation.
Right now, I have 2 ASA 5506-X in a Active/Standby configuration connected to a SG300-20 SM business switch via EtherChannel. From that switch I have another SG300-20 connected via LAG to our lab environment, I ha...
I have a weird issue that I am noticing since I went to a static IP service. In my log I am no longer seeing the destination IP address when it is beyond the outside interface. This is what I have in the log
6Jan 25 201716:34:19305012192.168.3.85743...
Hi,
I have configured my SPR to push traffic to the FirePOWER module and then configured the rules on the module to block outbound Geolocation restrictions. I have this working with no issue.
I would like ot do the reverse. Any traffic coming inb...
Due to the bug I discovered with FirePOWER version 6.1 I had to reimage the SFR module. I imaged it to version 6.0.1.2. The imaging process went fairly smooth, but now I cannot add anything to rules, objects, zones...etc, etc. The other sections of ...
Thank you for your reply, I am monitoring the logs as the connection builds and my public ip is all I am seeing as the destination when I visit a site on the internet.
I have been testing in a lab and this is what I have found. First I should have prefaced this with I am trying to set this up for AnyConnect. I noticed that there is no real way to put an inbound acl in place for AnyConnect access, like you normally ...
