Hi Guys
Is there any possibility to prime Access Point in a different Country?
Basically, I am located in Switzerland and need to configure some equipment which is sent to Saudi Arabia.
HiI got a few messages during a day that APs have been gone down:2. Message: 802.11b/g interface of AP MYAP is down: Controller 10.15.15.15A few minutes later the AP came back to the controller with the message:4. Message: Access Point 'MYAP' associa...
Hellois there a way for pre deploying the new ap images? We have around 500 APs and my inspection windows isnt long enough to upgrade via controller......
HiYou can push a configuration to devices via api.But there is no vlan api (exept for reading) You have to do the checks in your code (vlan exists already, properly configured etc.). Not really the support you expect from a api right?
Hi Jacob
Thank you. What a pitty Cisco is not able to provide this stencil.
But, i can not put this in the customers documentation, this is just not professional.
Facing the same issue actually. Some clients, a third probably, on a open ssid stuck in DHCP_REQ state. Even they got an ip address...
Did you got anything back from cisco?
Hi Scott
Yeah right. It is a lightweight 2702I-X- so i was wondering i can turn that into autonomous.
So it does not depend. i can convert any lightweight AP (X or pre-branded regulatory domain APs) into autonomous mode?
Kind regards