Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I created mesh using 1550 and 1260 AP series. One of 1550 is RAP with WLC wired, and others are MAP (1550 and 1260 series). All APs are in bridge mode with Mesh - Ethernet bridging enabled. All APs are visible in WLC in Wireless section and I ...
In this time its notebook for testing at home, but in real it is IP camera. Anyway, both are accessible locally but not via wireless and ethernet on 1260 series AP.Here is topology, look pls: http://www.bluegray.eu/topology.jpgOn this scheme - I can ...
When I connect my pc to ethernet of 1260 MAP I cant ping anything, I cant ping this pc from other side too. Although I have whole mesh connected and visible in my WLC. Devices conncted behind 1550 MAP works fine.I Found at http://www.cisco.com/en/US/...
I have only one untaggeg VLAN (id:0), all ethernet ports are placed in this vlan. I found problem, 1260 series doesnt support layer 3, therefore its impossible to access IP devices behind this AP. Its accessible only via layer 2, using MAC. Can you c...
Problem is not solved, FUS v7.4., code v7.4.100.0, IOS version for Aironet 1260 is 15.2(2)JB$. Mesh is visible in WLC, I can configure all APs, but still cannot access devices connected to ethernet of Mesh AP - Aironet 1260. It didnt works from othe...
Thnx, I downloaded it and started process: Upgrade Field Recovery Image from version 1.0.0 to 7.4.1.30I hope that it helps. I already downloaded new firmware fo Aironet 1260 - ap3g1-k9w8-tar.152-2.JB.tar, now I have version 12.4. Do you mean that it ...
