Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have just upgraded a 4215 sensor to ver 5, it was a replacement so I started afresh. I ran the setup and then entered IDM, under Interfaces I can only see one I/F fa0/1 the management I/F the monitoring doesn't appear, I have re-checked the sensors...
What is currently considered to be the best way to connect 2 Cat 6500’s together?These are on different floors with both fibre and copper linking them, I have read recently that a routed environment is the best option.In summary the Cats are 6500’s w...
Any advice would be greatly appreciated.What debug may diagnose the issue etc.ThanksMark Pix IOS version 6.3.2Cisco 837 router version 12.2.3XAProblem explanationVPN is set up between Pix and 837 ADSL router. Both can get out to the Internet. The Pix...
Can anyone please enlighten me?I have configured a 4215 Sensor running the latest version 4 software & signatures.I have configure the sensor to use a Pix to facilitate shunning, the configuration has been running for over a week and I have selected ...
So are you happy that it's working ?I'm just playing with ver 5 and having issues, there seems to be scant documentation. Ver 3 was based on Solaris and was very useable,it had a window showing the connection status between sensor and blocking device...
As far as never block addresses is concerned, my view is that you shouldn’t block you own range as you could create a denial of service on yourself.With regards to using the router as a blocking device you need to move your anti spoofing ACL from the...
It isn't easy to confirm connectivity, (it was in ver 3), I assume you can ping the router from the sensor, if you create a manual block on the sensor it should create the access-list on the router, if it is not created I'd look at the syslog out put...
Both really.The main switch has most users attached 60% and more servers are being located on the second switch due to space issues.Thinking about it more I expect it would be better to go for 4 switches (2 on each floor) and distribute users and ser...
Thanks for a prompt response.The redundant connection between switches I was wondering whether to use GEC (etherchannel) or have them as independent routed connections and use say EIGRP to load balance across them.I appreciate what you say about a sw...
