About sueper_mann

sueper_mann · 10-05-2004

I need to add a ws-6148v-ge-tx module to a 6513 configured as followed. What memory upgrades & swupgrades to I need to complete first?-----------------------WS-C6513 Software, Version NmpSW: 7.2(2)Copyright (c) 1995-2002 by Cisco SystemsNMP S/W comp...

sueper_mann · 03-02-2004

I'm trying to enable IPX routing on an WS-F6K-MSFC2.I have an IP routing option in gloal config, but notipx. Do I need to have special firmware for ipx?

sueper_mann · 10-28-2003

I have a 6513 switch configured with 2 supervisors/msfcs. HSRP is configured and onesup is active while the other is in standby mode.Monitoring some of the VLANs that we've configured,we've noticed that there is a high number of HSRPhello packets be...

sueper_mann · 09-23-2003

Here's my situation. I have 2 trunked switches.... One 6513 switch/with MSFC & a 6509 L2 swtich. The MSFC is set up with a couple of static routes and a default route that points to a router that providesinternet access for the entire organization....

sueper_mann · 09-24-2003

THANKS EVERYONE!! Actually the PBR solution is just what I needed. WORKS GREAT.

sueper_mann · 09-23-2003

i've tried to set it as follows with no success..------------------------------------------------access-list 4 permit vlan8_gateway!interface vlan8ip policy route-map test!route-map test permit 10 match ip address 4 set ip default next-hop 2nd_ro...

Member Since	‎09-23-2003 01:45 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	6

User Statistics

User Activity

ws-6148v-ge-tx addition

IPX routing

large number of hsrp multicasts

Internet access

Re: Internet access

Re: Internet access