Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1)I am running LMS 3.2, and it does not appear to properly identify 3750 stacks. While the member switches are shown in a detailed report, I would like to see each swith in a generalized device count. For example, on RME's home page instead of showin...
What would be the most effective configuration to generate a syslog when CoPP drops packets for a given class? I assume I need to work with the 1.3.6.1.4.1.9.9.166 OID, but I need guidance on how to incorporate into what I assume will be a TCL script...
I would like to create an EEM script that creates a syslog or trap when the AgPoliced-By counter increments under the "show mls qos protocol" command. It looks like maybe the 'event counter name x' may work, but I am having difficulty finding a list ...
We have a network management station on the 10.9.8.x/24 segment. This segment lives via HSRP on two 6500 switches. Whenever an end host attempts to connect to the station, they fail. Looking at the ICMP response time, we receive a constant 29-32ms re...
Is it possible to create a report on the top ICMP talkers and export it via email? I know I can pick ICMP and select specific IPs, but when I use 255.255.255.255 I receive no data. Please advise, thanks.
That's unfortunate. Maybe there is a quick and dirty way to extract the needed inventory/device-count from the detailed reporting. Thanks for your insight Marvin.
That was it. Thanks Joe!Can you verify my logic please? This applet monitors the specific given OID. When the class-map drops an average of 1000 bytes per minute over a 1 minute period, a message will be sent to syslog. Is this correct, and is this t...
It does:#show event manager history events Load for five secs: 13%/3%; one minute: 8%; five minutes: 8%Time source is NTP, 14:34:11.726 CDT Fri Jun 28 2013No. Job Id Status Time of Event Event Type Name1 563982 su...
