Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am trying to monitor the operational status of the IP Phone connected to a CTS-1300 through SNMP, however I found that the MIB (CISCO-TELEPRESENCE-MIB) related to this hardware does not specifically address this requirement. As far as I could ...
Hello Paula,Thank you very much for your reply!Couldn't find the information in a compact form in the beginning but your answer is definitively what I was looking for.Thanks once again.Regards,Gabriel
Hi,Appy a policy-map with the desired QoS policy to the tunnel interface.First of all, issue 'qos pre-classify' on the the tunnel itself, otherwise the congestion management mechanism will be useless.Cheers,Gabriel
