Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Group,my newly deployed Wireless has some little quirks. One of them is that APs on the same Controller (AP 1250 and WiSM) detect each other as honeypot - sending a trap, but than it is nowhere in the rogues (it shouldn't, so this is good) - bu...
I had the same problem a few days ago and was told it's a known bug and should be fixed in the next version. I'm running with 255.255.255.254 netmask now, that's not too bad as workaround until this is fixed...
Is it really "missing"? Or just greyed out?Because it is greyed out when doing AP-SSO (HA). You have to configure NAT IP before enabling AP-SSO, then it works as expected.
Hi,that is pretty bad, because I just ordered based on that document: http://www.cisco.com/en/US/prod/collateral/wireless/ps6302/ps8322/ps10315/qa_c67-714540_ps2706_Products_Q_and_A_Item.html(WLC HA Q&A) which states:"The two WiSM2 blades could be pl...
Hi there,the linked document states:"In order to achieve HA, WiSM-2 WLCs should only be deployed in a single chassis or deployed between multiple Catalyst 6500 chassis using VSS."So two 6500 in standalone mode (but with high bandwidth-connection betw...
If I may follow up on this one:"But it does not allow you to do WPA2/AES/802.1x on both profiles with the same SSID."Why not? This would be very handy, but is - like you said - not allowed.I mean, of course this setup does not make sense on *ONE ACCE...
