Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a scenario where we're moving providers and most sites will have two routers with a layer 3 switch. We'll have the single VPLS instance from the provider where all routers will be connected using private network 192.168.4.0/24. All routers wil...
I'd like to create multiple ipsec VPNs between 3 routers. Before applying i'd like verification on the config i've written to see if this will work. This is just the configuration on RouterA for the VPNs to RouterB and RouterC.As you can only apply o...
It can happen after reloading or inserting SFPs.See: CSCuj14019Symptom: %CMRP-3-UDI_AUTH: F0: command: Quack Unique Device Identifier authentication failed, show up on ASR1001 Router.Conditions: After reloading the box or inserting SFPs.Workaround: T...
Thanks for taking an interest. So yes the 350Mbps and 100Mbps are connected to both sites from the same WAN provider. It's connected using a single VPLS instance. Obviously the bandwidth is limited from the providers side.If the primary spoke router ...
@Lei Tian - In reply to trying to resolve asymmetric bandwidth issues, the current route path isn't asymmetric. With the bandwidth and delay settings already in place the route goes down and comes back the same path.I still don't see how you're going...
@KWillacey - i don't have an issue with getting the route down the preferred link, i.e. 350Mbps. That's easy, adding the delay command on the secondary router will acheive this.The issue is if both primary and secondary hub routers have QoS policies...
