Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I wanted to add an SG500X to an existing stack (Native stacked pure SG500X-Stack) and it always fails, all LEDs on, System LED blinking Amber (according to the Admin Guide this is Hardware failure).The eventlog on the Switch says, that boot code u...
Hi,we are using a WLC2504 with several Aironet 2602 Access Points.So far it is working fine but when I turn off the WLC all SSIDs disappear after some seconds as they couldn't find the controller anymore.Is it somehow possible to configure the Access...
Hi,I have a couple of SG500X Switches which need to be configured and I wanted to do this with a central managed tool to have an uncomplicated way to configure the switches.I already found Cisco Configuration Assistant, which supports the 200 and 300...
Hello,I want to use the internal DHCP Server of a SG500-Stack (Layer3-Mode) to assign addresses to several VLANs.I was able to create several Pools, but I didn't find any option to assign these pools to VLANs or Ports.For Example:Addresses from Pool ...
Managed to get this working: Switched back over to image 1 (1.2.9) and updated the boot code, worked like a charm.Then switched back to image 2 (1.3.5).Didn't try to add this unit to stack for now, but I think it'll work for now
pushIs there really no tool for the 500 Series?Seems strange to me, as 300 and lower have the CCA and Catalyst have CNA, only the 500 don't have any tool.
