Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Rob,Have you tried a different phone load ?Was it the same since intallation ? Will you be able to downgrade the CTS load ,the Midlet and let us know the feedback.RegardsShyam
Hi,Not sure if you are trying to get more than 500 participants in a single meeting. If not then MCU’s can be added separately in the Call control device. RegardsShyam
It depends on what is that to be achieved,If you are planning to load balance then TCS has to be clustered and the FQDN to be added.For TMS to provide an alias for recording , TCS can be added separately. Shyam
For resetting you shall try the below steps--------------------------- -Make sure the DMP is connected to the DHCP enabled LAN and Powered on.- Turn the DMP around and locate the "Reset" button on the back panel.- Take a sharp object (such as a Pen, ...
Here it seems you are trying to use the existing router (voice gateway) as for ISDN termination and the existing E1 PRI /E1 R2 for carrying Video traffic.In this case the PRI will be able to support the video , but you would have to check if Cisco ...
