Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a PIX 501 with VPN 3000 Client configuration. The config on the PIX is very simple, the VPN tunnel from the client side to the PIX works fine. It connects and also issues the client with IP address from the configured VPN IP Pool.But when I tr...
Hello Everyone,I'm new to VPN and would like to ask for advice/help, I have purchased a PIX 501 with OS 6.3(1) and also purchased the VPN Client software. My question is, how do I configure the PIX so that external users can use the VPN Client to con...
Hi Glenn, I'm new to PIX/VPN etc, I wanted to ask how do I setup a PIX 501 or 506 with ADSL. Our ISP will provide ADSL connection with 5 IP addresses. Can you point me in the right direction and or documents on the above matter and also on setting up...
Hi -Can someone please explain how I can avoid the following message when I power up my 1600 router:%SYS-4-CONFIG_NEWER: Configuration from version 12.1 may not be correctly understoodThe router boots up fine after this with the modified config. Here...
Hi Everyone..Can someone please provide me with a sample configuration of a PIX 501 with OS 6.2 or 6.3 connected to a ISP via ADSL Modem, I also need VPN (site-to-site) setup on the PIX so if you can provide this as well, it will be gratefully apprec...
Hi Glenn,I'm new to PIX/VPN etc, I wanted to ask how do I setup a PIX 501 or 506 with ADSL. Our ISP will provide ADSL connection with 5 IP addresses. Can you point me in the right direction and or documents on the above matter and also on setting up ...
Hi -Thanks for your prompt response on this, What I did was to change a few IP addresses on the router configuration, when I changed the IP addresses the Ethernet0, Serial0, Se0.1+Se0.2 were all on shutdown state. I made the changes and issued comman...
Hi Alan,Thanks for the reply, yes I'd be grateful if you could send me your config, if you don't mind can you post it to: surot_mia@hotmail.com - Once again many thanks for your help.Best regards,
