Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hej out thereI am suffering under that on the console of our FMCv01 the process which i assume is handling the SNMP requests apparently is dying. If i look trough the shell it looks pretty much alive and we can also do a snmp v2 query to it. Can some...
Hi out there - I have a funny issue - i simply cannot install a Cisco FMCv under my VMWare Workstation 17.6.4 - i have tried all versions more or less between FMCv 6.4.0 -> 7.6.2 - the VI versionThey import nicely and so on but when I start them it s...
hi out thereAfter i upgraded our FMC 2600 from 7.2.7 to 7.4.2 all FTD's suddely complains about SSE enrollment failure (9 FTD's in HA - 18 ) is this a known feature??
hi out thereWe have a couple of FMC 2600 running 2.7.2-500 which i would like to migrate to a virtual FMCv - i expected if i was on 2.7.2 on both "platforms" it would be simple - but no - when i load the backup on a FMCv running 2.7.2-500 it complain...
hi out thereis there some "simple" way of reducing the MTU size of a tunnel interface - a VTI ? We have a VTI which after the ipsec traverses trough a MPLS tunnel and we would like to set the MTU to f.ex 1300 bytes instead of 1500 - i cannot see any ...
ahh ok - so "easy" as it looked it was of course not. Since i have this FMCv running in parallel i have delete all devices - and hereby all our partner VPN's are not showing up neither. Sicne it is pretty important to us that these VPN's also are up ...
hi again - thanks for the suggestings - usng the script configure-model.sh i succeded in "faking" a FMC 2600 on the FMCv and was able to restore:so - ugrade steps for FMCv:1) ensure to have a fresh backup from source2) bring a FMCv up on the same sw ...
