Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I’m new with Meraki switching but familiar with Cisco.I have a MS120 for testing and I try to use NAC as I have on the Cisco devices.Some of my endpoints will be authenticated by MAC, others by Certificate (dot1x).After the endpoint is authent...
Hi all,I'm not sure about the settings of the"Antenna Configuration" for an 1852E Mobility Express Access Point. If I look at the datasheet for the 1852E, it notes that 2.4GHz uses 3 antennas. -> Does that mean that for Radio 1 only 3 Antennas need t...
Hi all,Running 8.8.111.0 on an 1850 Series, with 6 SSIDs configured, I'm not able to disable the FASTLANE option by Web-GUI.In the GUI I can select disable for the FASTLANE option and apply the settings. But entering the WLAN-setting again, the optio...
Hi all,
question, can I combine vtp mode transparent and vtp pruning?
My switches are in vtp mode Transparent.
Can I enter vtp pruning on the switch?
Where do I need to enter this command (all transparent switches)?
Thanks
Willem
Hi all,My customer has generated a certificate following this document:http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/109597-csr-chained-certificates-wlc-00.htmlThe key length is 2048 instead of 1024.the Uploa...
Not new at the forum but nothing posted yet.I like this Forum and the Meraki way of thinking.We have Access Points and Switches in use and happy so far.
Ok, I have to come back on this issue.It seems to be a single device, printer that has this behaviour, all my other printers do not show the same.The detrimental effect would have been flooding the RADIUS server with requests.I Guess I have a printer...
Hi PatoberliI have different Environment, some may be upgraded from older, others may have been reset and started with an 8.8. release.I could not try your solution yet, the AP is 2000KM from here, don't want to make it unavailable for me.I'll see if...
I updated to 8.8.120.0 but the result is the same, not possible to disable FASTLANE.Not in Web-GUI (you can change, apply but it does not disable it)Not in CLI:(Cisco Controller) >config qos fastlane disable 5Warning! This command will automatically ...
