Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just did an IOS upgrade on a new ASR 1001 router. After I do the upgrade, the permanent license I had for adventerprise changed from permanent to EvalRightToUse. Is there something that I must do to get it changed back t opermanent again? It appear...
Been tinkering around in our ACS 5.2 appliances today to setup PEAP. I generated a self signed certificate under local certificates which I want to remove now. But when I try to delete it I get the following message:This System Failure occurred: Cert...
We are getting ready to deploy 2 ASA 5520's to replace our PIX's. We were hoping to use the management interface on the ASA's. Currently we manage the PIX's via the inside interface. We have run into a problem that we cannot figure out. We have a lot...
I checked the ASR 1001 again and I did accept the EULA:Show License EULAFeature name EULA Accepted-------------------- -----------------------adventerprise yesHowever, when I do a show license right-to-use, I get a message that says, "%...
On our production PIX we have the following route statement:route inside 2.2.0.0 255.255.0.0 1.1.58.3 1On the ASA, we only have the managment interface connected to the network. I have to change the routing statement above to the one below to even be...
Isn't that going to prevent the traffic that needs to go through the inside interface from getting to its destination? Besides once I change the router statement from:route management 2.2.0.0 255.255.0.0 3.3.50.3 1to:route inside 2.2.0.0 255.255.0.0 ...
