Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to connect a monomode link that brings Internet from another branch office in one of four uplink ports of supervisory board 4507 switch and I'm not getting link, instead if I connect the fiber in the first port 3/1 I get it link, with this...
Estoy tratando de conectar un enlace monomodo que trae internet desde otra sucursal en uno de los 4 puertos uplink de la placa supervisoras de mi 4507 switch core y no obtengo link, pero si conecto la fibra en la boca 3/1 si me da link y negocia el v...
In a new implementation I have a 4507 l3 switch and I can not do that traffic go out throught the firewall.I post the main configuration------------------------------4507-------------------------------vlan 1093 name FWinterface Vlan1093 ip address 10...
Ayer fuimos al sitio y no pude hacer andar los segundos puertos de las supervisoras, las pruebas realizadas fueron las siguientes:1) Probamos conectar el SFP monomodo en los puertos Ten 3/2 y Ten 4/2 de respectivas supervisoreas y no obtuvimos link.2...
Ok, del link me quedo con lo siguiente Limitation and Restriction on Supervisor Engine 7-E and Supervisor Engine 7L-E •When you use WS-X45-SUP-7-E in RPR or SSO mode, only the first two uplinks on each supervisor engine are available. T...
Ohh!!! I see that the output configuration by shell mismatch with gui configuration, a bug???I rebooted asa and now the configutation is updated asavm01# sh configASA Version 8.6(1)2 !hostname asavm01enable password 9GsK.aUQ4.dpnEzg encryptedpasswd 2...
Nothing, the same results!I post actual configurations---------------sw4507-----------SW4507R_DC#sh runSW4507R_DC#sh running-config Building configuration...Current configuration : 11816 bytes!version 15.0no service padservice timestamps debug dateti...
