Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All:I'm not sure this is even a router issue but have a problem with a site to site tunnel created on our FW.The circuit in question delivered by ISP to our 3640. Router to FW vai FA0/1 which is assigned our global IP 66.52.5.xThe tunnel is set...
Hello All:I have no experience on PIX firewalls and am considering buying an older one on Ebay to work/train on and use in a lab environment. Can someone point to a model number that would be worth looking into? Someone suggested a PIX 515E?Any advi...
Hello All:Rather new to routing and am a little fuzzy on how to setup PBR. My scenarioI have an existing 3660 Router with a single T1 terminating in it. The attached 3x internal subnet by default will route out that T with the folowing route stateme...
Quick question. Have to add a subnet but am out of open fast ethernet ports on ouor router. I have an existing connection between 2 of our routers. If I add a secondary IP address on each side of this connection will I be able to route through the se...
Hello All:I really am not that good at access and need to restrict all traffic to 10.0.5.x network with the exception of 5 pc's who need full access. I know you create access-list whatever but I get a little confused about in out etc.Can anyone provi...
Rick - I'm not that experienced with Cisco Routers - inherited this from the previous guy who left the company, so I'm not sure exactly what I need.What I am concluding from your advice is that I can leave the default route in place which will take c...
Rick - Thanks. The T1 bundle routes out with default 0.0.0.0 0.0.0.0 214.x.x.xThe other T1 will route to the remote office. I will have to leave the default route up for the bundle since they route out to the internet and not a specific IP range. See...
