Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have tested Guest Network settings on EPC3928-A4CC-K9 running firmware 150116cAnd there is not possibility to set anything via Web page using admin account and based on the CM config file (applied after factory reset through the modem button)The...
Hi All,I have question regarding connecting two VLAN's on 7600.The schemat is like below:[7600] <-- TRUNK --> [SWITCH] |--PORT IN VLAN 1501--[PC1 IP 1.1.1.1 255.255.255.0] | |--PORT IN VLAN 15...
Hi Giuslar,the problem is that the GPON system has different VLAN for each PON endpoint device and each service on that endpoint device, so all what is going out of this GPON system is tagged traffic.I dit checked the VLAN translation, but it also do...
Hi p.bevilacqua,the problem is that in real this [Switch] I've mentioned is not a real switch. It is some GPON device which I have translated to the architecture of the Switch and PC's.So I cannot have different IP address in different VLAN, because ...
