My network locations typically have two routers, on is primary, but both are active. Both have tunnels out to the network, so in essence the routers are just redundant hardware. We build probes across one router, but, in order to keep the number of a...

Does anyone have a link or documentation that defines ALL the fields in a show ip sla statistics command? Some are clearly obvious, but in Packet Loss Values for instance what are the measurement values for Source to Destination Loss Periods Number: ...

Are there any recommendations, or things to look for, to correct udp jitter probes returning zero one way latency values? What are the determining factors for  NTP to be out of spec for instance? Documentation on Cisco's site is very vague, curious t...

are there any IP SLA dest-port limitations that anyone is aware of, or has documentation for? If I have a large network, and want to test to a core location, are there any limitations on the responder if the probes are set to use the same UDP port? I...

Can anybody clarify for me the total size of an IP SLA packet? We are going to be using UDP Jitter probes, and the way I see it it should be like this - Setup - 52 byte control packet exchange to set up measurement phase, thenMeasurement-20 byte IP H...