Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there I am trying to trunk port 1/0/24 on a Cisco 2960 to a Juniper 2300. I am getting the following error.SSWC-MEDIABOOTH-1#.May 23 21:18:30.358 MDT: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/24, changed state to downSSWC...
Hi there
one of our SFP cards went offline this morning and trying to see how I can power it back on.
2 Centralized Forwarding Card WS-F6700-CFC SAL1421J7DB 4.1 PwrDown
When I try to use the cli command I get this...
#hw-module module...
Hi there
I'm trying to connect to our Solarwinds Ftp Server but cannot. Can someone help with the access list that I created on our 6509? FTP does work, unfortunately port 22 does not. Any thoughts?Extended IP access list DMZ 10 permit tcp any hos...
Hi there
I'm trying to set up my DMZ server (10.0.0.10) to talk to server 172.18.1.114 through port 443.
and I want 10.0.0.10 to be able to get internet access and rdp.
I want to do that using an access list on our cisco 6509 switch. Can someone plea...
130 permit tcp any host 10.0.0.30 eq 22 140 permit udp any host 10.0.0.30 eq 22 160 deny ip any host 10.0.0.30
This is the correct line I used (ssh port 22). Can someone help?
Hi there
so where would i put the outbound rule to allow communication? Both servers are residing on the 6509. I'm not using the fwsm just an access list.
