Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Hopefully a simple question. I am unable to set flow control to ON on our Nexus 7K - by default it is set to OFF:Internal(config-if)# sh int e3/9Ethernet3/9 is upadmin state is up, Dedicated Interface Belongs to Po10 Hardware: 1000/10000 Eth...
When monitoring a specific flow on our CSS, "show flows" command output does not show this flow even when the user is actively using the content rule/ service. flow-timeout-multiplier has been set to 225 (1 hour). See below output when the "show flow...
I am using version 3.1.59.24. The WLC does not allow me to import/enable ssc certificate (Autonomous AP converted to lightweight). I have tried both CLI and WCS to do this. The command reference for 3.1 clearly shows that we can enable the ssc via co...
Our Nexus 5Ks are on 7.3(5)N1(1) - any idea if the ip sla feature is supported on this version?When I type "show feature | i sla" the output is blank.Thanks in advance.
When you say "After forming their list, they send LWAPP DISCOVERY messages to each controller", does the AP send a Unicast IP packet to each controller?We cannot see any packets other than IP Broadcasts from the AP even though the DHCP Option 43. Wha...
Yes, I know I can show all the flows. But because there are over a couple of hundred flows at any given time, I am doing a grep to just look at the flow I am interested in.Also, the CSS is deployed "in-line" not in a one-armed configuration.
Hi Steve,Thanks for your reply (was away for a couple of days so didn't see your posting).The CSS is actually "in-line" so the reply packets cannot bypass the CSS.Not sure why we do not see server to client traffic: Will this traffic contain server's...
