Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Probably worth noting to anyone reading these posts that things have moved on since this was posted and the IPv6 standards have only recently been ratified with a number of alterations and changes in best practice over the years, including the ...
Perhaps 6 years too late, but in answer to your question the MTU defined for your layer 2 switch doesn't include the Ethernet header (18 bytes including the CRC) so if it receives and IP packet which is bigger than 1500 then once it adds the Ethernet...
Hi Jason,I spoke with a supplier in the UK (Comstor) back in early January and they confirmed that, as Marvin has said, the newer version of Next Generation Firewall Service (ASA CX) software 9.2 does allow with operation with IPS at the same time, h...
Hi,I'm not sure if this has now changed with ASA CX software version 9.2 as the Q&A link that is referenced above is no longer present and the new entries state the following:-Q. Do Cisco ASA Next-Generation Firewall Services support IPS functionalit...
Hi Ravi,I am also looking at the same options and I was heading entirely in the ISE direction until I realised that there is not full support for non-WLC WiFi systems. So since I have an AP1141 this seems to mean that I would be as well to go with P...
