Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!Just wondering if it's possible to configure a DMZ WLC in such a way that it will accept a join request from an OEAP on a none-management (outside) interface? (Port As you can see from the attached diagram I’m trying to use the DMZ WLC as a p...
Although it's been a good couple of years since I originally posted my issue I thought it would be a good idea to post the solution in case someone else gets stuck in the same situation. The attached diagram should explain the workaround that was put...
Ok cool, thanks... As I don't have a spare WLC I went ahead and carried out the changes I mentioned above, and although I can now see the join request being processes (received/sent) by the WLC, the reply is never going to reach the OEAP as its sendi...
Thanks for the reply Scott, so just to confirm, you’re saying if I wanted to keep the same physical design the only alternative solution would be to deploy a second WLC dedicated to OE?But if I keep the same design I would need to make the following ...
What is the switch port configuration? Bear in mind that when you're using the AP as flexconnect the port needs to be configured as a trunk port, after that the WLC will see the avaliable VLANS.Sent from Cisco Technical Support Android App
