Fasthernet0/0 is down, Line protocol is down.Fastethernet0/0 is layer 1 which is physical layer?Line protocol is layer 2 which is data link layer?Sent from Cisco Technical Support iPhone App
the answer is:default route are used when a router has only one other router to which it is connected.is this acceptable?1)It is used for connecting a stub network2)used in hub and spoke topology3)used for connecting to an isp
as far as i know router-id is an ip address used to identify a router on a ospf area. there are three steps to router-id right?1)Configured a router-id2)highest ip address lookback address3)highest ip address on the active interface _________________...
Refer to the exhibit. What does JAX do with link-state packets from ORL?sends out its updated routing table to both ORL and BOS routerssends out the individual link-state packets out the interface connected to BOSqueries BOS to see if it has a bette...
