Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am doing a QOS config in the following scenario.I have a 250mbps MPLS circuit, where voice and data will both be passing. I know there are multiple ways to do this, just wanting some peer review on the plan below and see if I may be missing anythin...
Is there is any native way within an ICM script to collect the callers input digits (I know this is possible), and take those digits and send a fax to it (this is where I cannot find much information)?For example, say there were 3 options, and each o...
I had plans to configure a EEM script to send a email when an OSPF adjacency drops. I have an odd spanning-tree issue that I believe the drops are related to and I want to see if my suspicions are correct. This doesn't happen very often, and it's nor...
New Location. 1.5mbps DSL. A few phones, thin clients, and one desktop.Simple setup : 2960 ------ ASA ----- ISP (DSL) 1.5mbps up/downCouple questions:1. I have theoretically 1500000bits to allot out in this policy map. The desktop,thin clients, and d...
Documentation says this:"The stack master contains the saved and running configuration files for the switch stack. The configuration files include the system-level settings for the switch stack and the interface-level settings for each stack member. ...
I made a class for icmp, sure enough it would hit that class every time the SLA initiated it's ping. QOS has always been a subject I've never had to dive into much, but this has been good for me. I appreciate the help from you Joseph and Paul. I slep...
Thank you, I appreciate the discussion.It makes me a bit paranoid to place BGP within the same class as the VDI traffic. I am not worried about BGP affecting VDI (small tables), but worried about VDI affecting BGP. I understand your point with FQ, an...
This may be an extremely stupid question but if you were simply doing static routing over such a circuit, it is fair to say no class allocation would be needed for "routing".
Thank you for your reply Paul.For the routing class, we are doing BGP, I assume I could just mark the class for cs6? class-map match-any routingmatch dscp cs6Also, in regards to the bandwidth xx, do you know what would be the recommended allocation f...
Thank you, that is helpful. Kind of makes play it smart make sense - which got me closerIt is a strange problem from here. If I call the script, I can get it to play certain numbers, for example "1234567891", but depending on how I format the number,...
