Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,I know this is HP related but the forums over there are dire!..............Right I have just received 8x HP 2530-48G-PoE+ Switch (J9772A), applied a very basic config to these and tagged the port on the core (5406zl), now when its all co...
Hello,Just moved ISP's today, tested on a netgear router and all good..........now I want to put my cisco firewall back into action, I have a problem......Netgeat DG834 in modem mode > Cisco PIX 515I've set the outside port as:Use PPPoE > entered...
Hi,I know this is an old firewall but its just a simple firewall I need, my question is this.I am not getting any internet with my current config, see below:show conf : Saved : Written by enable_15 at 00:52:17.182 UTC Fri Jul 20 2012 PIX Version 6.3(...
Hi,I've been given 4 more public static ip's and would like to use one of them static ip's to point to my sharepoint box, for example i want to be able to access my sharepoint box\web site externally:212.xxx.xxx.01 - my public pix ip212.xxx.xxx.02 - ...
My static is assigned by DHCP but reserved, tonight i managed to put the netgear DG834 into modem mode and connect it up to a netgear firewall and it all worked fine, my confirm is below:Result of the command: "show conf": Saved: Written by enable_1...
Hi, Thanks for the reply, I've managed to sort it now with the following config below:interface ethernet0 auto interface ethernet1 100full nameif ethernet0 outside security0 nameif ethernet1 inside security100 hostname bmi-501-fw-1 domain-name buildm...
