Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can i used a normal RJ45 cross-cable to connect my 2 x Cisco 2650 routers? Both my router have VWIC 2MFT-G703 E1 Controller card. Can you also advise what configuration I need to apply on the routers to connect them back to back thru serial interface...
If I were to connect the two 2600 router back to back using a cross-cable RJ45 cable, how can I simulate a WAN connection with 2Mbps bandwidth? Is there a command to limit the thoughput to whatever I want?
