Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I'm having trouble with the logging in cisco. It started when I enable the debug ip packet command. I notice that after enabling it whenenver check the system log in csco 3750 it always show below image:what I want to see is the below image wh...
Hi All,Good Day!Just want to ask again for your help.I'am configuring Cisco 2801 but when I command the interface Vlan the ord vlan is not recognize.Is there any missing command?Please help! Attach is the screen shot.
Hi All,Can anyone explain to me the use of the following command in switch:switchport port-security aging time 2switchport port-security violation restrictswitchport port-security aging type inactivitymacro description cisco-desktopspanning-tree port...
Hi All,Just want to ask if 4-port serial HWIC-4T is compatible for the Cisco 2801?We need additional HWIC for Fast Ethernet but the problem is we don't have already slot for it.We already have two HWIC-2T 2-port serial which is inserted at slot 1 and...
Hi!Sorry for the late reply.Please see attach as requested.HOGP_B_CS01#show loggingSyslog logging: enabled (7179420 messages dropped, 0 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)No Active Message Discriminator.No ...
Nope, I'm not looking for logs before I clear it. What I want to see is the current messages in the cisco device. Even I down a port in that switch it does not show in the logging. It shows only the vty logs.
Hi cadet alain,I already did that but unfortately when I execute again the show logging it doesn't show the same log. It only showed below:It does not show the link state messages.
