Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, I have a question.... And was hoping for some clarification on video bandwidth used by a VC call. If you see the attached screen shot the Call rate from a end point for the call is 384kbps. But if you notice that the Transmit (199kbps) Vid...
Hi All,Just to share.I just upgraded my c20 from TC6.0.0 to TC6.3.1 (version that fixes the CVE-2014-0160 -aka Heartbleed bug).The upgrade worked fine but the interesting thing is that the user I used to log into the codec is gone after the upgrade. ...
Hello Friends..I have existing C20 that is registed to VCS Control running Software version:TC6.0.0.876266. Now I thought of trying to register this Endpoint to my CUCM 8.6.2. I know that there is a different firmware (COP file Release TC5.1.3-CUCM) ...
Hi Friends,From what I understand regarding this... Active Directory database (direct) authentication can be enabled at the same time as local database and H.350 directory service authentication.In such circumstances you could, for example, use the A...
Hi,From what I understand that the EX60 can be used as a PC Screen by connecting up the DVI Socket.Its also mentioned in the user guide that "Your EX60 will then serve as your PC screen outside calls" I am wanting to understand what will happen when ...
Hi Wayne,Thanks for the response.That is my understanding too. "384k" call is "384k up and 384k" down.To elaborate on my understanding..A 384k channel is established to send the stream captured from the camera out from endpoint and A 384k channel is ...
Just to share...I got this message as well On Call History"B2BUA rejected call on the Ingress with 486 Busy Here (Policy lookup response)"Upon looking at Conductor Logs>Event Logs> All Events I spotted the follwing..Level="WARNING" Event="A request a...
Hi Jason,What is the exact errors you are getting on the VCS?Also (on TMS) have you Enable TMS Agents found under Administrative Tools > General Settings is set to No by default. To enable the TMS Agent in the TMS, the administrator must set this to ...
