Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2960 that I'm having some QoS issues with. An example of my config is listed below.Extended IP access list IP_Audio 10 permit udp any any range 50000 50019 20 permit tcp any any range 50000 50019Extended IP access list IP_Video 10 ...
I'm needing to upgrade the Windows 2000 Server that our ACS 3.1 resides on. In some testing, I ran into the problem that we are not able to install ACS 3.1 on 2003. Setup quits and states the operating system is not Windows 2000.Does anyone know of...
I figured out my problem. The problem was with my access list. The access list in my configuration were the following:Extended IP access list IP_Audio 10 permit udp any any range 50000 50019 20 permit tcp any any range 50000 50019Extended IP...
I see the same result when trusting dscp in the policy-map as I do when assigning dscp in the policy map. When monitoring the fa0/1 port that the phone is connected to I see the DSCP EF value. When I monitor gig0/2 uplink port the dscp value is set...
It's your basic hub and spoke design. Clients and phones connect to the 24 Ethernet ports. Int gig0/2 is up linked to 4507 that is the main core switch for the building and the IP telephony server is plugged into the 4507. The service policy is appli...
Yeah, that's what it is looking like to me. If I monitor fa0/1 I will see the DSCP value set for both incoming and outgoing packets. If I then monitor gig0/2 I will see the DSCP value set to EF for packets destined for the phone/softphone. However...
I went ahead and changed the COS-DSCP mapping on the switch so that COS 5 maps to 46 as you suggested. After doing some more testing, this unfortunately did nothing to solve the problem I'm seeing on the switch. I should have stated before, that th...
