Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
So for an office that is running Nutanix (1 node and 2 node offices, depends on size) why would I use Nexus say 3k over a Catalyst 9000 series. I am not even considering Nexus 9k for these offices, these are not Data Centers, just larger offi...
Hello,
I have a project I have been given...I have two separate routers which will each be peering with a different ISP. I have a registered ASN and IP address block that I will be advertising. I would like to load share between the two ISP's. I ...
Hi,
We created "new" SVI interfaces on the core switch, all static routing no dynamic routing. Switches are all Layer 2 between core and MPLS router.
CORE ---> Trunk ---> L2 Switch--->Trunk--->L2 Switch---Router
Trunks on all switches have new v...
Hi, I am just looking for an explanation to this error message. I have a HA pair of 5525's that went nuts yesterday and this error showed up over a million times in about 20 minutes. It then started working again with no intervention from me, and I ...
Hi, I am looking for a simple configuration for a dmvpn network running eigrp with two hubs on a single cloud.Do i just create two nhs entries, nhrp map entries, and two multicast entries on the spoke router tunnel interfaces? And on the hub routers...
ip address 10.209.0.10 255.255.224.0 secondary - this encompasses the entire block we are using...
ip address 10.209.7.1 255.255.255.0 - this is only vlan110 which i was using to test from
Thanks Paul, I have looked over this design guide as this was the fist place i went. however, i cannot find a configuration example for dual hub/single cloud.i see the high level design and know you can do it. but it doesnt show what the configura...
