Hiten Thakkar
Level 1
Level 1
Member since ‎01-12-2011
‎09-05-2024

User Statistics

  • 14 Posts
  • 0 Solutions
  • 10 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Discussion Posts
First Comment
First Discussion
First Article
First Question
10 Discussion Posts
1 Reply
5 Replies
Certifications

User Activity

I set up a C1121-4P router for a friend with int gig0/0/0 facing the ISP with ip address dhcp. int gig0/0/1 192.168.1.1/24. See attached sh run. Vanilla Configuration not much security or complexity. After a power reload the GUI "https://192.168.1.1/...
Hi,We are deploying a boat load if C9300-48P loaded with Cisco IOS XE Software, Version 17.03.02a, RELEASE SOFTWARE (fc5) Cisco IOS Software [Amsterdam], Catalyst L3 Switch Software (CAT9K_IOSXE). We have Mitel phones for our VoIP. The following is a...
In the process of helping Site survey specialist to configure his C2800i AP for site survey I cam across the Cisco Documentation that mentions to configure a mini WLC post installation of "ME" image (thanks! Rasika V.) and then configure the AP, sinc...
Question  Hi! ISE v2.3 HA setup fell into my lap with colleague leaving for a better opportunity. Tried Global Training in class delivery didn't much help perhaps waste of time. I am seeking advice for reference to self training and knowledge to gai...
We recently deployed a Pair of Cisco 1921 with HWIC-4SHDSL-E  in Slot 0 at both ends Cpe and CO. Below is a snapshot of the configuration from the CO end. The roles are stricttly at Layer 2.controller SHDSL 0/0/0 termination co dsl-group pairs  0, 1,...
Community Statistics
Member Since ‎01-12-2011 02:01 PM
Date Last Visited ‎09-05-2024 08:19 PM
Posts 14
Helpful Votes Given To