About Abouregeila

Abouregeila · 07-07-2013

Dear Ones,I have been running around this issue since around 3 weeks now, i have the following setup :3 Cisco Switches - SG300-28P 5 IP Camera - 3S vision N6073What i was trying to do is to run those IP Cameras using POE through the above switch mode...

Abouregeila · 07-15-2013

Hi Tom,Sure thing, let us have a team viewer session today @ 6:30PM GMT . Will it be possible for you? if not , tell me what is the best time that suits your availability...

Abouregeila · 07-14-2013

Find below the power consumption screenshot of the Camera when its connected to GE1 port which is causing the camera to blink red which is like trying to boot up.

Abouregeila · 07-14-2013

Hi Tom,Yes i am pretty sure, i have called 3S vision and confirmed it, also i conducted 3 test in 3 different switches last week and the camera worked just like that " Plug & Play ".I have tested out 3 switches and they are :Cisco Switch 16 Port 10/1...

Abouregeila · 07-10-2013

Hi Tom, Tried that and still same results, the camera refuses to run.This is very strange, really...I was thinking of buying another switch, but the issue is i am not sure any more if it would work or not This is a waste of time / money really. I eve...

Abouregeila · 07-08-2013

Hi Tom,Firmware i am running is Sx300_FW_1.3.0.62.rosAlso refer to below link which contains the PDF file for the PIN configuration for the POE modules in the Camera. It shows the power pins in the RJ45 as Numbers 4,5 for +ve and 7,8 for -ve.http://s...

Member Since	‎07-07-2013 11:18 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	8

User Statistics

User Activity

SG300-28P (10/100/1000) Port type enforcement to 100 ?

SG300-28P (10/100/1000) Port type enforcement to 100 ?

SG300-28P (10/100/1000) Port type enforcement to 100 ?

SG300-28P (10/100/1000) Port type enforcement to 100 ?

SG300-28P (10/100/1000) Port type enforcement to 100 ?

SG300-28P (10/100/1000) Port type enforcement to 100 ?