Hi,I configured ASA 5510 for IPsec & SSL. We have a IT team and normal users. All connect to VPN, now i need to differentiate IT team and grant them access to DMZ network and normal users shouldn't access DMZ network. How to differentiate?
Hi All,This question looks silly but it is important for me.I am using Cisco Any connect 2.3 to connect to my ASA.Kindly look at the screenshots.When the first system gets connected, the IP information isIP: 192.168.200.1SM: 255.255.255.0GW: 192.168....
Hi,Is there any command to find the speed of the backplane. To my knowledge as we add the blades the speed differ and we can get the details from cisco.comIs there any command to find, this may look like a stupid question.
Hi,Can we configure S-2-S, RA and SSL VPN in one CISCO ASA, my concern is SSL VPN is used for 3-rd party users, where we need to restrict. and S-2-S for our customers again restriction. How can I achieve this.
Hi,We have FWSM sitting on 6509 chassis. Currently we are passing the traffic thru Pix and we have 10 VLANS in the INSIDE zone (Trust zone). Now my question isWe need to replace PIX with FWSM as the perimeter firewall.If i deploy FWSM and push the al...
Hey, I am doing same scenario with Cisco Nexus 9k. I have IDF racks across the building with two 2960-x in each IDF connecting back to pair of Nexus 9k with single fiber run from 2960-x to one nexus. need your thoughts on this
Hi,This is relevance to your first question.If you change native vlan to 4. I am not sure whether the hosts defined without vlan sits on Vlan1. I think it sits on Vlan 4.Second question: Restricting traffic between VLAN's.1) Create interface VLAN2) D...