Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, You can take a look on the following link that show how to setup the access list, class map and include it on the policy map that will send traffic from ASA to CSC module: http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-...
Hello, The issue might be caused because there is not a default route that will send traffic out to internet.Interface vlan 2 is the "outside" facing to Internet port (Ethernet0/0)There are 2 options:1- since you are dhcp on the interface vlan 2, it ...
Hi Diogo, what is the Led status from the failed ASA?Based on this, we could have an idea about the issue. In some cases it could be related to a RAM memory issue.
Hi, If you have another RAM memory available, try it and see if it works.This issue might be related to a failed RAM, if you have a valid smartnet contract with Cisco you can open a ticket with TAC and verify if the unit can be replaced. Regards,Harv...
Hi Diogo, The issue related to failed firewall could be related to a hardware issue, you may get some outputs from console session when the ASA is booting up. Try to boot up the firewall again, if this doesn´t work then you should open a TAC case so ...
