Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have an MPLS WAN configuration with multiple remote offices. Provider manages the edge equipment (1800 series routers). We also have (2) 1841 and (2) ASA5510's inside. (See attached drawing).Some of our remote sites are VPN connected with termination...
Having difficulty getting DHCP to act as I expect. Have a pair of 4402 WLC's at corporate with many AP's connected (non-HREAP). All works as expected. Have a remote site with AP's setup in H-REAP...but wireless clients are getting addresses from our ...
Have a remote site with multiple 1142N standalone APs. Have to replace some old AP's and would like to standardize on the 1142N. Plan on using the 4400 WPS to control them with H-REAP rather than having them hang out there alone, but want the backup ...
What took care of my issue was trunking the port the AP was connected to. In my case, I has Cisco gear on one site and HP gear on another so I had to get the syntax correct on each. Cisco wanted a truck and HP wanted the VLAN tagged. Then they would ...
Think what this comins down to is I can't create VLANs on my 1841 I am using in my lab to simulate my remote location. I am trying to change that over to an ASA 5505 to I can more closely simulate the 5510's they have at that site.Have the ASA in pla...
code is 6.0.182I have 4 H-REAP AP configured but I am testing in a lab environment with just one before I ship them off to the remote office to be installed.Controller is 4402 and AP is LAP-1142Nconfig is huge so I can't post it. We are running over ...
I have H-REAP working. The issue is that I get IP addresses assinged to my wireless clients from our corporate office when the AP is connected to the controller. If the link is broken, it works great and the clients get IP addresses from their local ...
