Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi experts,I am deploying a new WSA, but seem unable to upgrade AsyncOS - when I check for available upgrades, I receive the following error:Error—Failure downloading upgrade list.Everything else seems to be OK - I have time via the default NTP serve...
Hi All,Setting up PBR (on an 1841) for a client to route specific traffic via a SRP527W. Now the PBR policy seems to be working - I have debugged and confirmed I am getting policy matches and PBR is correctly forwarding the traffic to the SRP527W.Tro...
Hi experts, I have a problem with a new 2811 configured as a dial-in server using an E1 HWIC and PVDM2-12DM. The calls are answered, but it seems no IP details (neither address, nor default GW) are provided to dial-in clients. I noticed that Line Pro...
Thanks Kush.It does not appear to be DNS related. Authentication failure with manifest server:-------------------------------------------------------------------------------------------------------proxy.local> nslookup downloads.ironport.comA=61.9.19...
Have been hounding the distributor, but they just keep regurgitating the Smartnet contract details.A check for new feature keys results in no new keys available.According to the license activation document at:http://www.cisco.com/en/US/services/ps104...
Thanks Andy.I gather this is somewhere on the horizon of your roadmap, rather than just around the corner?Had hoped the answer may lie in an available firmware release.I take it these devices originate from the Linksys stable?Regards,Russell
That did the trick. Found I also needed to disable the idle-timeout on the Dialer interface as calls were being disconnected after 2 minutes. All good now.Thanks again.
