Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I'm facing an issue which doesn't happen all the time and I'm unable to determine the exact condition.
I'm trying to activate the following zoneset:
zone name vsan_200 vsan 200
member pwwn 20:00:00:25:b5:c0:ff:ee
member pwwn 20:00:00:25:b...
Hi,We have tens of Cisco 1131 AG access points connected to WS-C2960-24PC-S switches.This system work well for few years, but recently, we observe many access points that get very hot leaving black stains on walls above them.Some of them are actually...
Hi,
There are two MDS (9100 and 9200) connected using two standard FC connections.
The 9200 connected to N5K (standard FC) and the N5K connected to &k storage VDC using FCOE.
There are two VSANs, but I'm trying to activate the zoneset to only one of ...
Thanks, I really appreciate the detailed answer, considering the age of this thread.We'll go for a new setup soon. Any special recommendation for the Cisco AP? we're going to use them for Internet access only, no location/security application. The nu...
Hi, thanks for the response.If cabling was the issue here, then I wouldn’t observe this issue on so many APs.Also, I can see on many of our access-points black stains on the walls. Sucha as the attached image: Those access points are installed in Isr...
