Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I thought I had the ACL's figured out but this rule is bugging me:
interface Vlan40 description ((Servers)) ip address 10.100.40.1 255.255.255.0 ip access-group Secure-Servers out ip helper-address 127.74.118.150 ip helper-address 127.74.118...
Hi Guys,
My DMVPN sites were up and running fine however I recently upgraded my ASA 5520 from 8.31 to 8.47; this took all but 1 DMVPN site down. The ACL on FW is same for both but all spoke sites are stuck on MM no state for example:
10.151.62.254 1...
Hi All, I am trying configure URL for SSL VPN management access only. I have created 2 profiles, one for users and the other for management. I can select each profile from the drop down and they work fine. However if I want a different URL for one o...
Hi, I was wondering is it possible to create a backup for my site to site VPN connection? the remote end has a cisco Router whiich currently has a VPN connection to an ASA 5500. How would I know configure the same router to use another VPN on a diff...
Hi, I was wondering is it possible to create a backup for my site to site VPN connection? the remote end has a cisco Router whiich currently has a VPN connection to an ASA 5500. How would I know configure the same router to use another VPN on a diff...
Thanks I think I get it now. It's applied for all address leaving that switch from that Subnet or VLAN 40 and not the address range that belongs to vlan 40.
Thanks for your response.
Ok so if 147.77.130.83 does talk to 10.100.40.X surely when 10.100.40.X communicates back to 147.77.130.83 it will change the source address to 10.100.40.X so how can we see hits with source 147.77.130.83 to any? It should...
I put a capture on the Inside interface but not for return traffic instead to see outbound traffic. The ASA is sending to traffic to the Hub for one site (2nd page on the file attached shows this) but for the site not working it shows nothing outbou...
Thanks for your assist on this. I have run debug command on spoke and it shows this:
029371: Aug 25 08:39:52.314: ISAKMP:(0):purging node 441711265029372: Aug 25 08:39:52.314: ISAKMP:(0):purging node -492540660029373: Aug 25 08:39:52.314: ISAKMP:(0):...
Hi Dinesh, Thanks for your response. Yes it is enabled. Just to clarify :https://SSL_VPN_USER/ - this URL is for usershttps://SSL_VPN_USER/Management - This URL is for management When we access the https://SSL_VPN_USER/Management URL it takes us to t...
