Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, I was requested to investigate a wireless device that is experiencing a network issue. I ran a debug and the client associates to AP's and roams from AP to AP quite well. The debug line that stands out to me is:*dot1xSocketTask: Aug 07...
Being that Cisco doesn't have a stencil for the various ISE nodes, I decided to make one and share it with the Cisco Community. They're not perfect, but it's better then the ISE stencil that is available from Cisco and it'll get the point across whe...
Hello all, I'm looking into upgrading our 4400 series controller to 5508's. Currently we have a few sites that have 8-9 4404 100AP controllers and I'm looking to condense these down to either 3 5508-500 or 5 5508-250 depending on cost. I'm wond...
I am also experiencing this issue while using Netscaler as the load balancer. I Have a policy setup to allow PEAP and EAP-TLS coming in on a Called-Station-ID or specific SSID. PEAP works fine on this single SSID but EAP-TLS fails when it's using N...
Make sure your username and password under Telnet/SSH Parameters in the controller settings on Prime Infrastructure are the same as the GUI/CLI username and password on the physical controller. Configure>Devices>Controllers>select controller>propert...
