Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I currently have a router that doing EIGRP, below is its EIGRP:router eigrp Prod!address-family ipv4 unicast autonomous-system 150! topology base redistribute connected redistribute static exit-af-topology network 10.10.10.0exit-address...
Hi guys,I currently have 2 routers doing eBGP to advertise our public subnet /23 to the internet at Data Center 1 (DC1). There is an iBGP link between these routers, DC1_ASR1k_A and DCAS1k_B. The DC1's topology below is working well today.Due to netw...
Hi guys,I try to configure IPv6 with EIGRP for my topology; for some reason, the EIGRP routing table isn't learning the IPv6 subnet from its neighbor When I run 'show ipv6 route interface t0/0/0' on the router side and 'show ipv6 route interface e1/1...
Hi Guys,I have 2 pairs of Nexus switches, each pair at each location. They connect between 2 locations with 2 x layer 3 links, as shown in the diagram.I configured EIGRP routing for both sites for these 2 pairs. The EIGRP routing works; my question i...
Hello guys,
I have 2 routers that are connected to each other through interface G0/0. Before EIGRP authentication was configured, they could see each other as EIGRP neighbors. The moment I put in authentication on both routers' interfaces G0/0, the E...
Thanks. Just for my learning:If I don't have a VRF configured for my new interface g0/0/0, would this 'redistribute connected' command in EIGRP Prod advertise my prefix 172.16.16.0/20 into it?Does EIGRP have command to do route leaking between VRF?
Thanks so much for your advice. I've been working on a lab to simulate it in the last few days. We'll see how it works out before order equipment/services.
Currently, at DC1, ISP A is the primary ISP. Ingress traffic has come to ISPs A and B but ISP A gets more ingress traffic. more than 80% of egress traffic prefers ISP A. I don't have any AS prepend either router A nor is B of DC1. I'm advertising our...
