Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, its possible to configure as-override for BGP in FTD? I dont find the right option in the Management Center. FlexConfig is not possible. Kind regards, Michael
Hello,i have a problem with a Failover Pair of 5510. The Boxes run with the software version 8.2.5.If the Active ASA goes down, the Standby ASA switch to Active.Now the problem.If i switch on the old Active ASA, both ASA are Active. This problem don'...
Hi all,can i do this with the ASA5505?i plan to use the Lease Line only for VPN Traffic and the PPPOE Line for Internet Traffic.Configinterface Vlan1nameif insidesecurity-level 100ip address 172.20.1.1 255.255.255.0 !interface Vlan2nameif outsidesec...
Hello all,we are planing to install a Cisco ASA in China.Can we downgrade the Cisco ASA55XX 3DES/AES License to a DES license?We find only the option for a Cisco PIX on http://cisco.com/go/licenseWhere can I find the right license?mfgMichael
Hi Jonathan,
why i need a license for the FMC? Cisco writes the following on his website:
"
Cisco Firepower Management Center Data Sheet - Cisco
Ordering information
Licensing
St...
Hallo,the problem has been solved. The entry Trusted DNS Domains was wrong. Right Syntax of Domain List were: Trusted DNS Domains: *domain.local, domain*mfgMichael
Hello ajay,the configs are correct.-- Active --interface Ethernet0/0 no nameif no security-level no ip address ! interface Ethernet0/0.5 vlan 5 nameif outside security-level 0 ip address 1x.x.x.210 255.255.255.248 standby 1x.x.x.211 ! interfa...
